Correlated responses on growth traits after two-stage selection for ovulation rate and litter size in rabbits.

Rabbit commercial maternal lines are usually selected for litter size (LS) and paternal lines for growth rate (GR). Line OR_LS was selected by ovulation rate (OR) and LS to improve LS more efficiently. In this study, growth traits of line OR_LS were evaluated by estimating the correlated response on weaning weight (WW), slaughter weight (SW) and GR during fattening period as well as their variability (DWW, DSW and DGR, respectively). Data were analyzed using Bayesian inference methods. Heritability estimates were low for growth traits (0.09, 0.13 and 0.14 for WW, SW and GR, respectively) and negligible for growth traits variability (0.01, 0.004 and 0.01 for DWW, DSW and DGR, respectively). Moderate common litter effect ratio (c2; 0.35, 0.28 and 0.27) and low maternal effect ratio (m2; 0.11, 0.05 and 0.01) were obtained for WW, SW and GR, respectively. Both c2 and m2 were lower at slaughter than at weaning. In addition, low common litter effect and negligible maternal effect were observed for growth traits variability. Genetic correlations between LS and both growth traits and their variability were close to zero. Positive genetic correlations were observed between OR and growth traits (0.19, 0.38 and 0.36 for WW, SW and GR, respectively) as well as between OR and growth traits variability (0.35, 0.62 and 0.20 for DWW, DSW and DGR, respectively). Positive correlated responses in both periods were obtained for growth traits, WW, SW and GR (0.037, 0.156 and 0.110 kg, respectively). The correlated response found in growth traits might be due to the positive genetic correlations between OR and these traits. However, selection for OR and LS using independent culling levels did not modify the growth traits variability. Therefore, no negative consequences on growth traits can be expected in current commercial maternal lines.

Correlated responses on litter size traits and survival traits after two-stage selection for ovulation rate and litter size in rabbits.

Farmer profit depends on the number of slaughter rabbits. The improvement of litter size (LS) at birth by two-stage selection for ovulation rate (OR) and LS could modify survival rate from birth to slaughter. This study was aiming to estimate direct and correlated response on LS traits and peri- and postnatal survival traits in the OR_LS rabbit line selected first only for OR (first period) and then for OR and LS using independent culling levels (second period). The studied traits were OR, LS measured as number of total born, number of kits born alive (NBA) and dead (NBD), and number of kits at weaning (NW) and young rabbits at slaughter (NS). Prenatal survival (LS/OR) and survival at birth (NBA/LS), at weaning (NW/NBA) and at slaughter (NS/NW) were also studied. Data were analysed using Bayesian inference methods. Heritability for LS traits were low, 0.07 for NBA, NW and NS. Survival traits had low values of heritability 0.07, 0.03 and 0.03 for NBA/LS, NW/NBA and NS/NW, respectively. After six generations of selection by OR (first period), a small increase in NBD and a slight decrease in NBA/LS were found. However, no correlated responses on NW/NBA and NS/NW were observed. After 11 generations of two-stage selection for OR and LS (second period), correlated responses on NBA, NW and NS were 0.12, 0.12 and 0.11 kits per generation, respectively, whereas no substantial modifications on NBA/LS, NW/NBA and NS/NW were found. In conclusion, two-stage selection improves the number of young rabbits at slaughter without modifying survival from birth to slaughter.